The Netgear WNDAP360 router has 300mbps WiFi, 1 N/A ETH-ports and 0 USB-ports.
Netgear WNDAP360 default Password , Login & Gateway settings :
Default Gateway IP: 192.168.0.100
Netgear login instructions
Default username: admin
Netgear router default password list
Default password: password
Default subnet mask: 255.255.255.0
Default DNS server: 192.168.0.100
How to factory reset (hard reset) Netgear WNDAP360 :
You can factory reset your Netgear WNDAP360 in the following way(s)
With the reset button
Have the router powered on (if just booted wait around one minute for it to load)
With a sharp pen or paper clip, press down the Restore Factory Settings button and hold it for about 7 seconds
When the power light starts to blink you can release the reset button and wait for the router to start up
The power light will be solid (not blinking) once the router is started.
How to login to the Netgear WNDAP360 :
Make sure you are connected to the router’s network, either by Wi-Fi or ethernet cable.
Open your browser and visit
You should be prompted with a login dialogue.
Enter the username: admin
and the password password
You will now be logged in. If you haven’t yet changed the defaul password, we recommend that you change it first
thing you do after logging in.
Netgear WNDAP360 router specifications :
RAM: 128 MiB
Flash: 8 MiB
Custom firmwares: OpenWrt
WiFi: 300mbps (abgn)
2.4GHz & 5GHz
WiFi throughput: n/a
1 x N/A port
Netgear WNDAP360 review (quick overview)
Here is the quick comparison of how the Netgear WNDAP360 compares to
other routers on our site
For a full list of routers and how they compare to the WNDAP360, check the
Router Buying Guide which will help you buy the most
Staying up to date with the latest firmware is a good idea to keep your router even more
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the Netgear WNDAP360
Flashing OpenWrt on the Netgear WNDAP360
The Netgear WNDAP360 is supported by OpenWrt according to their Table of
flashing OpenWrt onto it should be quite straigthforward.
We couldn’t find any specific instructions for flashin OpenWrt on the Netgear
WNDAP360, but since it’s listed in their Table of Hardware as supported, you can
over to the
OpenWrt install instructions and read on there.
Note: Flashing custom firmwares is always on you’re on own risk. Make sure to
read OpenWrt’s wikis to understand the risks and how to proceed if something goes
Netgear stock firmware for the WNDAP360
Stock firmwares for the WNDAP360 are available under the download section on the
support page. You can also refer
to the router’s manual for instructions on how to upgrade the firmware.